Where I Have Been

Hi.

Remember me?

I don't know how many people are going to be reading this post; probably not at all since I discontinued this blog around a year ago (check the time stamp.) The thing is, I went into multiple hobbies, wrote and finished a whole trilogy, and finally started coding and programming seriously. 

I even started a YouTube channel from which I post vids about said coding and programming. That is where I actually post now; check it out if you're interested. I am a student, so videos and posting are usually held back by my studies, so updates are irregular.

Thanks for sticking around.

Sincerely,

Phoenix


PS: This is my YouTube channel if you're interested. https://www.youtube.com/channel/UCsWgxhyExfS8ir1r1rtiw5Q/featured 


Comments

Post a Comment

Popular posts from this blog

How to Make a Breastplate (Part 1: The Front)

Image
I guess I will warn you at the beginning that you would not be able to move your arms as much with this model, but it would protect you better. So, it seems to me that the breastplate is one of the most important parts of a set of cardboard armor. (I'll be honest with you; I've got two full sets, and I'm making a third one because I've outgrew the other two.) Well, let's ump right in! The first thing you would need to do is to make sure you have enough cardboard. Breastplates need a lot of cardboard. Also a lot of hot glue. make sure you have enough! (A roughly estimated amount would be enough to build and glue a cubish box two and a half feet wide.) This is very complicated to explain, and I have two models, so I will just show you the model I used to build a costume of the armor of Genghis Khan. (don't ask) Take a sheet large enough to cover your chest(from just below the belt to your collarbone.) and cut it evenly in half. This will be the two sides of the fr...
Read more

How to Build a Breastplate (easier)

Image
Building a breastplate is easy and simple. Down below, I will show you how. So the first thing you will need is two sheets of cardboard large enough to cover your torso. Cut them both in the shape you want, like down below:  You would want to do the same for the other side, which will be for your back. Decorate now if you wish. then punch two holes at the top for your arms and two holes at the bottom for your sides. Loop some string through them, and you're good to go!
Read more

How to Make a Durable Cardboard Sword

Materials You Will Need: large sheets of cardboard aluminium foil, paint, or markers clear packaging tape a few short wooden skewers or dowels small rolls of clear tape scissors a pencil  Introduction:       In general, cardboard swords are floppy, flimsy, and easy to bend. Once bent, they will just lean over to one side and stay there until the bent part gets torn off. And trust me, that is not fun, especially if you are in the middle of a gladiator match with your violence-loving sister.     I've made quite a few cardboard swords, yet my method may not be the best. The swords still break eventually, but at least they will not need as muck repair if one just traced the form of a sword on cardboard and cut it out. (Tried that, did that, and it failed.)      Okay! If you made it this far, applause for you. Now let's jump into it! Step 1: Getting a Backbone     This is critical for the durability of your sword. I ...
Read more